WTB..Rear Torsion Adjuster

Tonz Magonz · Post by **Tonz Magonz** » Mon Feb 04, 2013 10:32 pm

Looking for a weld in rear centre torsion adjuster..

Post by **jnr356** » Mon Feb 04, 2013 10:32 pm

http://www2.cip1.com/ProductDetails.asp ... 26-501-200

Tonz Magonz · Post by **Tonz Magonz** » Mon Feb 04, 2013 11:17 pm

Thanks Mark..
Cheaper than rhe sway a way brand too....

Thought I'd ask as I recall someone on here buying them in the past but maybe they just talked about it ..

NUG637 · Post by **NUG637** » Mon Feb 04, 2013 11:42 pm

Dib put then in tex

Post by **jnr356** » Mon Feb 04, 2013 11:44 pm

feedback?

OMR_007 · Post by **OMR_007** » Wed Feb 06, 2013 4:48 pm

awesome

nate · Post by **nate** » Wed Feb 06, 2013 5:04 pm

So that would act like a beam adjuster?

Post by **jnr356** » Wed Feb 06, 2013 5:05 pm

Tonz Magonz · Post by **Tonz Magonz** » Wed Feb 06, 2013 7:14 pm

Hey Dib,
Is the overall width of the adjuster component ,less than the cast section that the torsion tubes are originally welded too..

Im thinking of shortening tubes from the centre, so will need one of these adjusters before I get serious with the grinder..

nate · Post by **nate** » Wed Feb 06, 2013 8:13 pm

jnr356 wrote:

That's a yes?

I've never seen these before, I'm interested to see how they work.

Tonz Magonz · Post by **Tonz Magonz** » Wed Feb 06, 2013 10:18 pm

Basically, the splined section the inner ends of the torsion bars are located in, is allowed to rotate by screwing in or out, the threaded bolt you see in the pic..

OMR_007 · Post by **OMR_007** » Fri Feb 08, 2013 12:56 pm

Nate / Tonz, there are pics in TEX's build thread

Tonz Magonz · Post by **Tonz Magonz** » Sat Feb 09, 2013 9:13 am

Thanks Dib,
I looked and enjoyed the read but couldnt tell how much narrower the adjuster is than the factory cast section..
Any idea.?

NUG637 · Post by **NUG637** » Sat Feb 09, 2013 9:19 am

Fairly sure it's a straight swap if I'm thinking what your thinking...

Tonz Magonz · Post by **Tonz Magonz** » Sat Feb 09, 2013 9:52 am

Thanks mate..
Time to buy..